Household 3D printing round 3: Lampshades and Gardening

Greenhouse over planter box

     Been busy with helping wind-down the garden and cleaning up for the winter over the past couple of weeks, this included converting one of the beds into a mini-greenhouse. The core materials are 25-30 square meters of transparent plastic sheeting for the shell, a couple of 12 foot lengths of 1 inch plastic tubing and some 1/2 inch electrical conduit (EMT) off-cuts from the old Proteus build. Obviously this collection of components needs some way to connect everything, that's where 3D printing comes in with custom adapters and clamps.

Frame hoop anchor bracket with EMT  connector and plastic tubing.

      The frame is formed from the 1" plastic tubing with the EMT conduit used as corner posts that are anchored with connectors that I'd made for another project over the summer, basically a corner anchor to connect EMT to wood or other sheet material. Installation is fairly simple, two screws hold the bracket down to the planter box, then the EMT gets inserted the bracket and the plastic tube is slipped over the top to form the main arches. Cross bracing is provided by both the outer plastic sheeting and a cross-beam formed from some spare 1" tubing with more custom brackets.

Cross-beam connector in white PLA

     The outer plastic shell is held down by custom clips that clamp onto the 1" tubing in a 270° arc. So far it's stood up to a fairly intense rainstorm with minimal issues, a couple of the clips were overwhelmed by the wind and their position on the frame but it's easy to fix by printing slightly tighter ones for those spots.

Plastic sheet clamping clip in use

     The other project I've been working on is spiral lampshades using parametric design in Fusion 360, mainly as a way to learn more about the program and to replace a couple of ancient dust-trap shades that had gotten impossible to clean.

Twisty Lampshade fresh off the printer

    The form I settled on is a 7-sided cylinder, 25 cm tall and 19 cm in diameter. I started with a lofted form to create the slight curve to the sides and then hollowed it out to have 1.2mm thick sides for optimum light refraction. The material is basic white PLA without any heat-treatments or other modification after printing, and it's held up perfectly fine with an old incandescent bulb in the lamp.

Lamp with incandescent bulb and PLA shade.